产品详情

Features of 1200℃ High pressure high temperature tube furnace：

1. Heating temperature up to max. 900°C or 1100°C, Depends on tube alloy.
2. Nickel-base super alloy processing tube is included.
3. Max pressure up to 800 PSI.depended on tube alloy.
4. Double layer steel casing with air cooling to keep furnace surface temperature lower than 60°C.
5. High purity fibrous alumina insulation for Max. energy saving.
6. PID automatic control with 30 steps programmable. Automatic over-temperature and thermal broken protection
7. One set of high positive pressure flange.
8. The pressure sensor is installed in the flange. The pressure will be displayed in the pressure controller
in the front panel of furnace. The alarm system is built in the pressure controller which allow user to set
up the high and low limit point of pressure. When the measuring pressure exceed limit point, the alarm
strobe and whistle will be activated for warning.
9. The furnace is able to be controlled by a computer. And the software and USB cable are included.

Descriptions

Tube	Ni based super-alloy ( Waspaloy or equivalent)
	OD 60 x ID 52 x Length 1000 (mm)
Working Pressure vs. Working Temperature	1160 PSI (8.0 Mpa) max. at ≤800°C
	700 PSI (4.8 Mpa) max. at ≤900°C
	348 PSI (2.4 Mpa) max. at ≤1000°C
	230 PSI (1.6 Mpa) max. at 1100°C
	Never heat up above 1100°C
	Pressure calculation based on safety factor 2 for 4,000 hours service life )
Pressure Measurement Range	0~15Mpa
Max. Heating Temperature without Loading	1100°C
Working Gases	Inert gas, hydrogen and oxygen
Heating Temperature	1100°C max.for < 1hr
	1000C for continuous
Heating Rate	≤20°C/min
Heating Element	Fe-Cr-Al Alloy doped by Mo
Heating Zone	Total length: 440mm Single zone
	Constant temp. zone: 150mm ±1°C
Temp. Control	PID control method with over-temp protection
	Temperature stability: ±1°C
Positive Pressure Sensor	Installed in high pressure flange
PC control	Yes
Pressure Alarm System	Upper limit and lower limit control method
	Alarm strobe and warning whistle
Voltage	AC 220V 50/60Hz
Power	2.5KW
	(20A breaker required)
Flanges & Fitting	One pair of CF-63 flange and copper gasket is included
	One 1.5meter long, 1/4" high pressure flexible tube is included for connecting to gas tank and gas-inlet furnace tube. Max. working pressure 200bar.
	Please never use ordinary SS tube to connect to gas-inlet for using > 5Mp pressure, which may cause tube exploded. The safety pressure relief valve is available to be installed at the downstream side.

Note: there are different Chamber(Tube) sizes for your choice.




生产厂家哪家好？1200℃ High pressure high temperature tube furnace-洛阳赛特瑞高温实验炉Sintering Furnace为专业的生产厂家，具有多年的研发与生产经验、质量稳定可靠 TAG: